Dimensions:
Nominal length, pivot-stylus	12"
Distance required between turntable surface and cabinet lid	1.375"
Distance required below top surface of motor board	3.5"
Height adjustment 12	0.75"
Tracking adjustment	+ or - ½"
Radius clearance at rear for weights	3¼"
Distance from center of turntable spindle to arm pivot center	12.08"
Set tracking adjustment for zero error at 2.375" radius
The arm is normally installed so that the center line of the bedplate is radial with the turntable. If this is not possible, the bedplate may be turned to another position provided the requirements for correct alignment are met
E&OE ~ This information is provided as a guide and no determination as to the accuracy of the information is given here. If in doubt or you have any questions please ask or refer to the OEM if applicable