|
Breuer Dynamic Tonearms:
TYPE 5
|
|
Overall Length:
TYPE 5A, 5B, 5C = 8.976 inches (228 mm)
TYPE 6A = 1.315 inches (262 mm)
TYPE 7
TYPE 8
Distance from turntable spindle to arm pivot point:
TYPE 5 = 8.189 inches (208mm)
TYPE 6 = 9.638 inches (244.8mm)
TYPE 7 = 9.112 inches (231.44mm)
TYPE 8 = 9.112 inches (231.44mm)
Dynamic mass:
TYPE 5A = 4.0 grams
TYPE 5B = 3.3 grams
TYPE 5C = 4.0 grams
TYPE 6A = 3.9 grams
TYPE 7
TYPE 8
Distance from arm pivot point to arm rest hole:
TYPE 5 = 4.96 inches (126mm) and 0.315 inches (8mm) left of center line
TYPE 6 = 6.30 inches (160mm) and 0.315 inches (8mm) left of center line
TYPE 7 = 6.69 inches (170mm) and 0.315 inches (8mm) left of center line
TYPE 8 = 6.69 inches (170mm) and 0.315 inches (8mm) left of center line
Tonearm pillar mounting
Diameter of mounting hole = 0.6 inch (15mm)
Radius for locating collar mounting screws = 0.65 inch (16.5mm)
Cartridge Mounting
Stylus Point = 0.157 inch (4mm) in front of headshell forward edge
Recommended Tracking Range = 1 to 2 grams
Cartridge weight range = to 8 grams (use special counterweight if heavier)
Use good quality tracking force balance to set exact tracking weight
Tonearm height adjustment is via mounting collar
Antiskating adjustment via dial on top of pivot assembly (1/3 ccw turn equals approx 1g tracking force)
Please note that the Breuer Dynamic tonearm was designed intentionally without a finger lift. The arm should not be lifted by hand. Instead the cueing device should be used to raise and lower the arm, which can be moved horizontally by sliding it along the cueing device with one finger.
Return to HOME page
All trademarks and rights belong to the OEM and are reproduced here for information purposes only
E&OE